Applicable Product: Nyquist C4000
Applicable Release: 7.0.1.535
Fixed in Release  : 11.0.0 and higher
Patch Filename    : c4000-7.0.1.535-patch2.tar.gz
How to apply patch: Use "System Update" in the "System Parameters" view of the Nyquist web interface.

This patch provides support for NQ-ZPMS-G2 and video calling between NQ-ZPMS-G2 phones.

This patch resolves the following issues found in C4000 Release 7.0.1.535:

[NYQ-8262] - Fixed an issue where, when using Automatic Failover, the NQ-SYSCTRL is sourcing the RTP traffic from the Primary or Secondary IP Address instead of the Shared IP Address specified in the SDP.
[NYQ-8352] - Fixed an issue where enabling TLS caused the server to fail to read the CA certificate, resulting in Nyquist appliance service disruption.
[NYQ-8498] - Fixed an issue where certain NWS Alerts would fail to display.

Firmware Update

This Nyquist server software patch also deploys an updated firmware version (NyqUpdate-5.3.9) for all Nyquist Appliances.

Important Note - NYQ-8262 (Automatic Failover Reconfiguration Required):

After applying this patch, Automatic Failover must be reconfigured for the fix to take effect.

Required steps (on both Primary and Secondary servers):
1) Click "Disable" on Primary and Secondary servers.
2) Click "Save" on Primary and Secondary servers.
3) Re-run the configuration using the Setup Steps section on the Automatic Failover page.